foreskin restoring device
foreskin restoring device
foreskin restoring device
Using the DTR in Dual tension mode
To use the DTR in dual tension mode some skin to work with when flaccid is needed. With some experience this whole process takes only 5 seconds to do and comes off in 2 seconds making it fast and easy to use. Please view both "rolling" and "pushing" methods of installing the DTR.
This method allows me to control very precise the amount of tension I want to use. It is a very good way to use high tension settings. The more I  push down on the push rod the more the skin is tightened creating more tension.
As you can see in this photo you cant really tell I have it on even with boxer briefs ! I have worn it with all types of clothing with no problems. Nobody had any idea I was restoring.
I adjust tension by pushing the push rod down and tightening the stainless steel tension hold screw. The stainless steel screw will press against the push rod keeping it from moving. Very little tightening is required.
I put on the DTR just as I would when using elastic tension but without the elastics.
Manual tension using the tension hold screw
Using elastic tension
Pressing my glans against the push plate.
I roll my shaft skin onto the DTR bell.
Rolling the gripper on my skin
Attaching the elastic one end at a time.
Here I am using two elastics for higher tension.
Fully installed elastic tension.
[ Home ] [ Contact ]
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
Even with shorts I had no problems. This makes the device an all season any occasion restorer!

If I was using a hard tension setting and it became uncomfortable I could just slip my hand in my pocket and release the tension screw. This is a great feature when in a public place.

I do not use as a DTR while sleeping due to night time erections.
Doing so could damage the skin tissue from lack of circulation!

A simple tightening of the hold screw and it is secured
Many ask if the DTR is bulky and can it be seen under clothing.
If I want to place more tension on one side of the shaft skin than the other I can do so by installing the DTR slightly to the left or right instead of straight on.

So for example if I wanted less skin growth on the right side I would place the DTR slightly to the right side of the glans. Then when tension is applied it would pull more on the left side.
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
foreskin restoring device
Applying the DTR  "push method"
This method was developed by a DTR user on restoringforeskin.org it was developed for guys that may find it difficult to attach the DTR when they are first starting out with restoring.
Step one : Place the glands against the push plate.
Step two :Instead of trying to roll the skin onto the Bell, I instead press the push Rod and push plate into the glands and pull on the shaft skin as shown.
Step three : I keep working the push plate against the glands as I pull the skin up.
Step four : I now roll the skin down to the edge of the push plate.
Step five : Keeping the skin just on the edge of the push plate while holding the push plate against the glans.
Step six : I now bring the Bell down to the push plate, careful not to pinch the skin in between the Bell and push plate.
Step seven : I now roll the skin forward onto the bell.
Step eight : Rolling the gripper onto the skin just as I normally would.
Attaching the DTR this way can concentrate more on inner skin growth.
It also changes the position of the DTR so that it "hangs" more comfortably if this is an issue.

Applying the DTR "rolling skin method"
Since there are two surfaces of the skin you can control which surface receives more stress by using the two different methods.
Since there are two surfaces of the skin you can control which surface receives more stress by using the two different methods.
Need more gripping power ?  New to restoring and want the most grip possible ?
check out Silicone skins ( condom catheters ) For a cheap way to get even more gripping power.
Guys who are intact with a tighter end to the foreskin may want to skip steps five and six and go directly to step seven at this point. This way you do not have to expand the end of your foreskin.
Click video screen to play in new window ( you can save the video also )
This restoring method has been around for many years. Also called bi-directional and what I referred to as dual tension because of the push / pull effect on the skin. This method does require a little more skin to work with so anyone that has a tight circumcision might want to use the tugging method first.
This method is my number #1 method to use.
Great for inner and outer skin development. Can be used with any desired amount of tension by using elastics or the tension hold screw.
Parts needed for Dual tension:
  • DTR bell pack
  • 1 Push rod
  • 1 Push plate
  • Elastics (optional)
No, I never had an elastic snap and slap me in the dick or balls.

Caution! Being too aggressive can lead to injuries such as skin tears and bruising or possible other damaging injuries. I've had done this personally in the past from being too aggressive with my routines. Always use your own judgment on how you choose to restore. Pain is not part of restoring. The information on this web site is to show how I personally choose to restore and is not intended as instructions or medical advice on how everyone should restore. What you choose to do with this information you do at your own risk.